DIN 1.1191 C45E Steel is a general carbon engineering steel according to DIN Germany standard. It’s one kind of high strength carbon steel which is mainly used after quenched and tempered. The 1.1191 steel has a certain shape and toughness and high strength. After QT, C45E steel can obtain good comprehensive mechanical properties. The welding performance of 1.1191 steel is not so good. This material needs to be preheated before welding, and carry on the annealing treatment after welding in order to eliminate the welding stress.
DIN 1.1191 steel is applied to manufacture high strength movement parts,such as air compressor,piston pump,the impeller of a steam turbine,heavy duty and general machinery of the rolling shaft,connecting rod,worm,rack,gear,etc.
C: 0.42-0.50; Si: max0.40; Mn: 0.50-0.80; P: max0.030; S: max0.035; Cr: max0.40; Ni: max0.40; Mo: max0.10;
AISI/ASTM: 1045, Germany: CK45, BS: 080M46, JIS: S45C, UNI: C45
Round / Square / Flat Bars, Shafts, Rollers, Blocks
– As Forged
Round bar: Size: Dia.80-1,000mm, Length: 3,000-10,000mm
Square bar:Size: 150×150-600×600mm, Length: 3,000-8,000mm
(Forged Flat Bars, Shafts, Rollers and Blocks can be Customized)
– As Rolled
Size: Dia.10-300mm, Length: 3,000-10,000mm(can be Customized)
Tensile strength: 600MPa
Yield point: 355MPa
Percentage reduction of area after fracture: 40%
Elongation after fracture: 16%
Impact test(+20°C): Transverse – 14J; Longitud – 39J
Quenched and Tempered (+QT) of 1.1191 Steel:
1. Increase the temperature slowly up to 840°C;
2. Soak at this hardening temperature and quench 1.1191 steel in the oil;
3. Cool down to 20°C in the air;
4. Heat uniformly to the tempering temperature of 600°C;
5. Hold at this temperature for 2 hours per 25mm thickness
6. Withdraw from the furnace and cool in the air.
Normalizing (+N) of DIN C45E Steel:
1)Heating din 1.1191 to 850°C;
2)Cool C45E material down to 20°C quickly in the air.